Coyote Point Systems Equalizer Especificaciones descargar pdf (Pagina 495)

100

101

Setting Up an SNMP Management Station

An SNMP management station is not provided with Equalizer. In order to use SNMP to manage Equalizer, a third-

party management console must be installed and configured on a machine that can access Equalizer.

Configuration procedures are specific to the management console used.

At a minimum, the SNMP management console needs to be configured to:

l Use Equalizer’s IP address and port 161 for SNMP requests.

l Use the community string specified for Equalizer (Refer to "SNMP Commands" on page 176 or "SNMP" on

page 198).

l Use the address and port specified in the above for SNMP traps (usually port 162 is used for this purpose,

but this can be configured as shown in "Enabling SNMP Traps" on page 497).

l Use Equalizer MIB definitions; these need to be loaded into the management console, following the

instructions for the console. The Equalizer MIB source files are located at:

http://<Equalizer-ip>/eqmanual/CPS-EQUALIZER-v10-MIB.my

http://<Equalizer-ip>/eqmanual/CPS-REGISTRATIONS-v10-MIB.my

http://<Equalizer-ip>/eqmanual/cpsSystemEqualizerv10TrapsB.my

In the above, <Equalizer-ip> is the IP address of the Equalizer. On the Equalizer, these are

located in the directory /usr/local/www/eqmanual.

Enabling SNMP

Note - SNMP is enabled using the CLI.

By default, SNMP is a globally enabled service -- meaning that it will run on any subnet that is configured to offer

the SNMP service. You must specifically enable SNMP on the subnet or subnets on which you want it to listen for

SNMP MIB browser and management station connections.

SNMP can be enabled on

at most

one IPv4 subnet address/port and one IPv6 subnet address/port. SNMP runs on

Equalizer’s IP address on the configured subnet. Currently, SNMP runs on the default SNMP port (161) only.

To enable SNMP, you must enable it at the global level, and then enable it on any single IPv4 subnet, any single

IPv6 subnet, or both. For this procedure, we assume the existence of a properly configured VLAN (172net) and its

Default subnet.

1. In the global CLI context, confirm that SNMP is globally enabled:

eqcli > show

You should see a line that looks like the following:

495

Equalizer Administration Guide

1 2 ... 490 491 492 493 494 495 496 497 498 499 500 ... 593 594

Comentarios a estos manuales

Sin comentarios

Coyote Point Systems Equalizer Especificaciones Pagina 495

Comentarios a estos manuales

Relacionado con productos y manuales para Ecualizadores de audio Coyote Point Systems Equalizer