
eqcli > vlan [internal vlan name] subnet [internal subnet name] default_
route [IP address]
4. If there are any static routes configured for the external network, replicate that static routing configuration
on the internal (server) subnet.(See "Configuring Subnet Destination Routes" on page 111).
Managing Interface Ports
All Equalizer GX models have two Ethernet adapters on the motherboard.
On the E350GX, E450GX, and E650GX, the interface ports on the front panel are connected to both adapters. This
allows any port to be configured to work with either adapter. There is no default VLAN port configuration in Version
10 -- you can create VLANs and assign ports to them as you like using the CLI or the GUI, as described in the
previous sections of this chapter.
The E250GX does not support VLANs. The E250GX has two ports, each of which is connected to one of the
Ethernet adapters on the motherboard. A single port-based (untagged) VLAN can be configured on each interface.
Configuring Front Panel Ports
Front panel ports are configured using the either the CLI or GUI.
By default, all switch ports are configured as follows:
l full duplex
l full autonegotiation (Equalizer will attempt to auto negotiate the highest available speed with the unit on the
other end of the connection)
If needed, ports can be configured to match specific port settings required by the server connection. For example,
you could use the switch interface to configure a particular switch port to be 100Mb/s and half-duplex to
accommodate older hardware.
Viewing Link Status and Port Settings
Viewing Link Status and Port Settings(CLI)
The current link status of each port as well as the current settings, use the "show interface" command as in this
example from an E450GX:
Copyright © 2013 Coyote Point Systems. A subsidiary of Fortinet, Inc.
All Rights Reserved.
107
Equalizer Administration Guide
Comentarios a estos manuales