Coyote Point Systems Equalizer Especificaciones descargar pdf (Pagina 289)

100

101

The fields on this screen are as follows:

Protocol

The protocol selected in the Add Cluster form will be displayed “grayed

out”.

VID

The VLAN ID number assigned to the VLAN on which the cluster resides.

Refer to "Common Equalizer Networking Scenarios" on page 82 for

details.

Enter the IP address, which is the dotted decimal IP address of the cluster.

The IP address of the cluster is the external address with which clients

connect to the cluster.

Port

For TCP protocol clusters the numeric port number on the Equalizer to be

used for traffic between the clients and the cluster. For TCP clusters, the

port defaults to 80. This port also becomes the default port for servers

added to the cluster (though servers can use a different port number than

the one used by the cluster).

Preferred Peer

Used with Active-Active Failover. Refer to "Configuring Active/Active

Failover Between Two EQ/OS 10 Systems" on page 456 for details.

Server Pool

A drop down list used to select a Server Pool, or grouping of servers, to

which the cluster will communicate with.

Abort server

By default, when a client closes a connection, Equalizer waits for a

response from the server before closing the server connection. If this flag

is enabled, Equalizer will not wait for a response before closing the

connection to the server; instead it sends a TCP RST (reset) to the server

when the client closes the connection. This option will typically reduce the

number of server connections in the TIME_WAIT state, as shown by the

289

Equalizer Administration Guide

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 593 594

Comentarios a estos manuales

Sin comentarios

Coyote Point Systems Equalizer Especificaciones Pagina 289

Comentarios a estos manuales

Relacionado con productos y manuales para Ecualizadores de audio Coyote Point Systems Equalizer