Coyote Point Systems Equalizer Especificaciones descargar pdf (Pagina 225)

For example, Hurricane Electric provides what they call “regular” tunnels and “BGP” tunnels. For Equalizer, you

would choose a “regular” Hurricane Electric tunnel, which is a 6in4 tunnel.

A 6in4 tunnel allows a user to access the IPv6 internet by tunneling over an existing IPv4 connection from an IPv6-

enabled host to one of Hurricane Electric's IPv6 routers on the internet. Once a tunnel is established, the IPv6

enabled host sends IPv6 traffic over the local IPv4 network by encapsulating IPv6 packets inside IPv4 packets.

These packets are sent to the IPv6 routers operated by the tunnel broker, unencapsulated, and then the IPv6

packets are forwarded to the IPv6 internet.

Note - You can use IPv6 cluster addresses without establishing a tunnel on Equalizer if your organization already has established an IPv6

tunnel and Equalizer can send IPv6 traffic through the local tunnel endpoint. In this configuration, you would simplyassign cluster IPv6

addresses from the subnet associated with the already established tunnel and route the IPv6 traffic through the tunnel endpoint. This is

done with the standard subnet configuration commands.

Configuring an IPv6 Tunnel

Setting up an IPv6 tunnel on Equalizer is basically a two step process:

1. Configure a VLAN over which Equalizer can reach the IPv4 Internet, and request a "6in4" tunnel from a

tunnel broker.

2. After you receive the tunnel configuration information from the broker, set up the tunnel endpoint on

Equalizer.

Once the tunnel is configured, you can perform additional tasks required to get Equalizer clusters on the IPv6

Internet, including:

l Assigning cluster IPv6 addresses from the subnet address range provided by the tunnel broker.

l Updating DNS to point to the tunnel broker’s DNS servers.

Creating a "6in4" IPv6 Tunnel (CLI)

1. Configure a VLAN and subnet to use as the local IPv4 endpoint for the tunnel using VLAN context

commands (See "VLAN and Subnet Commands" on page 186). Note the following:

l The IPv4 address assigned to the subnet must either be a routable IPv4 address or resolve to a routable

IPv4 address via Network Address Translation (NAT) on another device.

l The routable IPv4 address associated with this VLAN is the one that is supplied to the tunnel broker as the

local endpoint of the tunnel. Changes to this address must be coordinated with the tunnel broker.

l The ports (both tagged and untagged) that are assigned to this VLAN are the ports on which the IPv6

address block assigned by the tunnel broker will be accessible.

2. Request a "regular" tunnel using Hurricane Electric’s website at:

http://www.tunnelbroker.net

When providing the local IPv4 endpoint address, use the IPv4 address assigned to the VLAN subnet

225

Equalizer Administration Guide

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 593 594

Sin comentarios

Coyote Point Systems Equalizer Especificaciones Pagina 225